Electrical Requirements; Power Supply Cord - Garrison 043-6127-2 Manuel D'instructions

6
Model No. 043-6127-2/043-6128-0/043-6129-8/043-6130-2/043-6131-0/043-5499-2 | Contact us: 1-800-268-6591

ELECTRICAL REQUIREMENTS

• The Portable Air Conditioner should be connected to a 115 V, 60 HZ, 15 A fuse,
grounded 3-prong outlet.
• The use of a time-delay fuse or time-delay circuit breaker is recommended.
• All wiring must comply with local and the national electrical codes and be installed by a
qualifed eletrician. If you have any questions, contact a qualifed electrician.

POWER SUPPLY CORD

NOTE: Your air conditioner's device may differ from the one shown.
To test your power supply cord:
1. Plug power supply cord into a grounded 3-prong outlet.
2. Press RESET (on some devices, a green light will turn on).
3. Press TEST (listen for click; Reset button will trip, and on some devices, a green light
will turn off).
4. Press and release RESET (listen for click; Reset button will latch, and on some devices,
a green light will turn on). The power supply cord is ready for operation.
NOTES:
• The Reset button must be pushed in for proper operation.
• The power supply cord must be replaced if it fails to trip when the
test button is pressed or fails to reset.
• Do not use the power supply cord as an off/on switch. The power
supply cord is designed as a protective device.
• A damaged power supply cord must be replaced with a new power
supply cord obtained from the product manufacturer and must not be
repaired.
• The power supply cord contains no user serviceable parts. Opening
the tamper-resistant case voids all warranty and performance claims.
WARNING:
!
• Plug into a grounded 3-prong outlet.
• Do not remove ground prong.
• Do not use an adaptor.
• Do not use an extension cord.
• Failure to follow these instructions can result in death, fre, or
electrical shock.
All manuals and user guides at all-guides.com
Electrical Shock Hazard
A
B
A. Test Button
B. Reset Button