Philips HF320 Mode D'emploi page 8

reached in the wristband, pressurisation is stopped and the
measurement starts.
Note: the blood pressure meter will automatically increase
the pressure in the wristband if the pressure in the
wristband turns out to be too low during the measurement.
Remain seated in a relaxed way.
• During the measurement the pressure in the wristband will
be slowly reduced and the
indicate that the measurement is in progress.
• When the measurement has been completed, the cuff is
automatically depressurised.
Your systolic pressure (SYS), diastolic pressure (DIA) and
pulse (PUL) will now appear on the display.
You can switch the appliance off by pressing the START
button again. If you forget to switch the appliance off, it will
switch off automatically after three minutes.
Memory
The appliance automatically stores
previously measured values in the
memory. Up to seven measurements
can be stored. You can retrieve this
data in the following way:
- Press the MEMORY button; the data
of the most recently stored
measurement is displayed.
All manuals and user guides at all-guides.com
8
symbol will appear to
138
080
140
145
078
081
077
079
076