Getting To Know The Xtc-100/150; Batteries; Micro Sd Card; Recording - Midland XTC-100 Manuel

Getting to Know the XTC-100/150

Batteries

1. To insert the batteries, push down the battery door latch on the
right side of the camera. Door will release. Push forward to
remove.
2. Install 2 AAA batteries observing polarity.
3. Return battery door and click into place.
*Note: We recommend using Lithium batteries in cold weather.
Battery Status
Indicator
Solid Green
Solid Red
Blinking Red*
No Light
*Note: When the red battery LED begins blinking, be prepared
to change the batteries because the camera will stop recording
at this point.
**Note: Quality of battery directly effects the record time.

Micro SD Card

1. Open and fold down the back rubber cover.
2. Insert Micro SD card into slot observing proper direction (shown below).
3. Return rubber flap into place.
Meaning
Indicates full battery life
Indicates half battery life
Indicates low battery life
Batteries are dead
www.midxtc.com
Getting to Know the XTC-100/150

Recording

1. Move the RECORD switch forward. This turns the camera on.
2. The battery indicator will light from red to green. The SD card indicator
will light green. The record indictor will begin flashing red after 8
seconds. This indicates the camera is capturing video.
3. To stop recording, move the RECORD switch back to the off position.
Note: The camera will continue recording for 3 seconds after toggling the
switch to the off position.
SD card LED
Status
Green 1 GB or more available.
Orange 512 MB to1 GB available.
Below 512 MB available or
Red
no micro SD card installed.
Flashing Red Cannot read the card.
Flashing Green Indicates card has been reformatted.
Memory Size
512 MB
1 GB
2 GB
4 GB
8 GB
16 GB
32 GB
Note: The camera automatically splits the video into 2 GB
segments.
Meaning
Record Time
7.5 Minutes
15 Minutes
30 Minutes
60 Minutes
120 Minutes
240 Minutes
480 Minutes
3