Lubrication - profiline A-ST 18V Notice D'utilisation

• Switch the tool on.
• Follow the line.
• For cutting perfectly round shapes, install the
trammel bar and set it to the required radius
(fi g. J).
Sawing up to a Projecting Edge (fi g. K)
• Using a conventional blade, cut up to the projected
edge.
• Finish off the cut using a fl ush cutting blade.
Dust Extraction (fi g. G)
• When the tool is used indoor for extended periods
of time, use a suitable dust extractor designed
in compliance with the applicable Directives
regarding dust emission.
Sawing in Metal
• Mount an appropriate saw blade.
• Proceed as described above.
CAUTION: Use a cooling lubricant (cutting oil)
to prevent overheating of the saw blade or the
workpiece.
MAINTENANCE
Your BTI power tool has been designed to operate over
a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper
tool care and regular cleaning.
WARNING: To reduce the risk of serious
personal injury, turn tool off and
disconnect battery pack before making
any adjustments or removing/ installing
attachments or accessories. An accidental
start-up can cause injury.
The charger is not serviceable. There are no
serviceable parts inside the charger.

Lubrication

LUBRICATING THE GUIDE ROLLER (FIG. C)
• Apply a drop of oil to the guide roller (7) at
regularintervals to prevent jamming.
All manuals and user guides at all-guides.com
Cleaning
CHARGER CLEANING INSTRUCTIONS
Optional Accessories
Consult your dealer for further information on the
appropriate accessories.
Protecting the environment
Should you fi nd one day that your BTI product needs
replacement, or if it is of no further use to you, do not
dispose of it with household waste. Make this product
available for separate collection.
53
WARNING: Blow dirt and dust out of the main
housing with dry air as often as dirt is seen
collecting in and around the air vents. Wear
approved eye protection and approved dust
mask when performing this procedure.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts
of the tool. These chemicals may weaken the
materials used in these parts. Use a cloth
dampened only with water and mild soap.
Never let any liquid get inside the tool; never
immerse any part of the tool into a liquid.
WARNING: Shock hazard. Disconnect the
charger from the AC outlet before cleaning.
Dirt and grease may be removed from the
exterior of the charger using a cloth or soft
non-metallic brush. Do not use water or any
cleaning solutions.
WARNING: Since accessories, other than
those offered by BTI, have not been tested
with this product, use of such accessories
with this tool could be hazardous. To reduce
the risk of injury, only BTI, recommended
accessories should be used with this product.
Separate collection. This product must not be
disposed of with normal household waste.
Separate collection of used products and
packaging allows materials to be recycled
and used again. Re-use of recycled materials
helps prevent environmental pollution and
reduces the demand for raw materials.
E N G L I S H