Description (Fig. A); Intended Use - profiline A-ST 18V Notice D'utilisation

E N G L I S H
Charges Li-Ion battery packs.
See technical data for charging time.
Package depends on the type of battery
used
1 Cordless jigsaw
1 Anti-splinter shoe insert
1 Anti-scratch shoe cover
1 Dust extraction shroud
1 Dust extraction adapter
1 Instruction manual
1 Exploded drawing
NOTE: Model packed in the box does not include
batteries or a recharging unit.
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fi g. A)
WARNING: Never modify the power tool or
any part of it. Damage or personal injury could
result.

INTENDED USE

Your A-ST 18V jig saw is designed for professional
cutting of wood, steel, aluminium, plastic and ceramic
material at various work sites (i.e., construction sites).
DO NOT use under wet conditions or in presence of
fl ammable liquids or gases.
These heavy-duty jigsaws are professional power tools.
DO NOT let children come into contact with the tool.
Supervision is required when inexperienced operators
use this tool.
1 Variable speed switch
2 Safety lock
3 Sawdust blower control
4 Blade latch
5 Finger guard
6 Blade holder
7 Guide roller
8 Shoe
9 Pendulum stroke selector
10 Shoe lever
11 Battery pack
12 Release buttons
13 Charger
14 Charging indicator (red)
All manuals and user guides at all-guides.com
Electrical Safety
The electric motor has been designed for one voltage
only. Always check that the battery pack voltage
corresponds to the voltage on the rating plate. Also
make sure that the voltage of your charger corresponds
to that of your mains.
If the supply cord is damaged, it must be replaced by
a specially prepared cord available through the BTI
service organization.
Mains Plug Replacement
(U.K. & Ireland only)
50
Your BTI charger is double insulated in
accordance with EN 60335; therefore no earth
wire is required.
DANGER:
• Should your mains plug need replacing
and you are competent to do this,
proceed as instructed below. If you are in
doubt, contact an authorized BTI repair
agent or a qualifi ed electrician.
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely;
a plug with bared copper conductors is
dangerous if engaged in a live socket
outlet.
• Only fi t 13 Amperes BS1363A approved
plugs fi tted with the correctly rated fuse
(1).
• The cable wire colours, or a letter, will be
marked at the connection points of most
good quality plugs. Attach the wires to
their respective points in the plug (see
below). Brown is for Live (L) (2) and Blue
is for Neutral (N) (4).
• Before replacing the top cover of the
mains plug ensure that the cable restraint
(3) is holding the outer sheath of the
cable fi rmly and that the two leads are
correctly fi xed at the terminals crews.
WARNING: NEVER use a light socket.
NEVER connect the live (L) or neutral (N)
wires to the earth pin marked E or .