3- Remote Control Keys - MCZ MAESTRO Manuel D'installation Et D'utilisation

3- REMOTE CONTROL KEYS

3- REMOTE CONTROL KEYS
REMOTE CONTROL FUNCTION KEYS
PRIMARY FUNCTION / SECONDARY FUNCTION
KEY
1 MENU / ESC
2 MODE / LEFT
3 ECOSTOP (ON/OFF) / n.c.
TEMP UP/ POWER UP / MENU SCROLLING
4
TEMP DOWN / POWER DOWN / MENU SCROLLING
5
6 TIMER (ON / OFF) / OK
With KEY 2 it is possible to modify the air (COMFORT DYNAMIC OVERNIGHT POWER MANUAL) or hydro (ROOM/BOILER/PUFFER/DHW) stove
operating modes.
Use KEY 3 to enable and disable the ECOSTOP function.
Use KEY 4 to increase the temperature set in COMFORT SET (COMFORT DYNAMIC OVERNIGHT) or to increase the flame power if in MANUAL
mode
Use KEY 5 to decrease the temperature set in COMFORT SET (COMFORT DYNAMIC OVERNIGHT) or to decrease the flame power if in MANUAL
mode
Use KEY 6 to enable and disable operation with the programmable thermostat
Use KEY 7 for rotation selection (V1 - V2 - V3) of the fan you want to modify
Use KEY 8 to enable and disable the NO AIR function
Use KEY 9 to increase the fan level of the selected fan
Use KEY 10 to decrease the fan level of the selected fan
Use KEY 11 to switch the product on/off. To switch the stove on/off, keep the key pressed for approximately 3 seconds. When the stove is
switched on, "LAVORO" (WORK) will be displayed on the screen of the remote control.
Attention! For as long as the stove is in start-up mode, adjustments (Room temperature/flame power/ventilation and
pre-set operating mode - COMFORT/DYNAMIC/OVERNIGHT/MANUAL/POWER-ROOM/BOILER/PUFFER/DHW) are not carried
out. Wait for the screen to display LAVORO (WORK), which indicates that the stove is in OPERATING mode.
52 52 52
1
2
3
4
5
PRIMARY FUNCTION / SECONDARY FUNCTION
KEY
7 FAN SELECTION / RIGHT
8 NO AIR (ON / OFF) / n.c.
9 VENTILATION UP (+) / n.c.
VENTILATION DOWN (-) / n.c.
10
ON / OFF / n.c.
11
12 DISPLAY
12
6
7
8
9
10
11
EN EN