2- General Information; Main Features; Package Contents - MCZ MAESTRO Manuel D'installation Et D'utilisation

2- GENERAL INFORMATION

2- GENERAL INFORMATION

MAIN FEATURES

Microcontroller
Antenna
Power supply
Voltage (V) Max/Min
Consumption (A)
Connectivity
Display
Temperature sensor
Accuracy
Resolution
Operating temperature (°C)
Storage temperature (°C)
MODE
The remote control will communicate with the board via the emergency panel currently installed on Maestro products and will use the
WiFi 2.4GHz technology for exchange of information with the stove.
A self-learning function is provided, which will enable simple pairing between the remote control and the equipment.
The remote control is equipped with a temperature sensor to read the room temperature and operate as a wireless thermostat.

PACKAGE CONTENTS

The remote control is supplied fully assembled. The product must be supplied with 3 AA batteries (batteries NOT included), as follows:
• Remove the cover of the battery compartment (bottom part of the remote control).
• Extract the battery holder compartment
Attention! Do not pull the battery holder compartment so as not to disconnect the cable applied to the board
• Insert the batteries according to the correct polarity (+) and (-).
• Reassemble the battery holder compartment
• Close the battery compartment cover.
The remote control has a special icon on the display to indicate when the batteries are almost flat.
If the flat battery icon appears, the batteries are almost flat and the remote control is about to switch off.
If the batteries are almost flat, a control transmission/reception failure may occur. This should not be considered as
a defect; change the batteries as soon as possible.
Used batteries contain metals which are harmful to the environment, so they must be disposed of separately in
appropriate containers.
ATTENTION! For all the various functions mentioned in the remote control manual, refer to the descriptions detailed
in the manual of each product with MAESTRO technology.
ATTENTION! If the remote control should fall, check the position of the batteries, which may come out from their
housing.
Technical Dept. - All rights reserved - Reproduction is prohibited Technical Dept. - All rights reserved - Reproduction is prohibited
Espressif ESP32 Wroom 32E - Single 2.4 GHZ WiFi and Bluetooth combo chip ultra low
power - Dual core 32 bit
Internal PCB Antenna
Batteries - 3 x (AA -1.5V)
3V/5.5V DC
0.3uA – 150mA
WiFi 2.4 GHz NB. The BLE is disabled from FW and cannot be enabled
1.54" EPD Display 152px x 152px
Digital - 12bit
+/-1°C
0.1°C
0 / +50°C
-20 / +65°C
EN EN
51 51 51