Advice Regarding The First Wash Cycle; Technical Data - Hotpoint LFF 8M121 Manuel

Masquer les pouces Voir aussi pour LFF 8M121:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Anti-condensation strip
EN
After installing the dishwasher, open the door and stick the
adhesive transparent strip under the wooden shelf in order
to protect it from any condensation which may form.

Advice regarding the first wash cycle

After the installation, remove the stoppers from the racks and
the retaining elastic elements from the upper rack, if any.
Immediately before the first washing, completely fill the salt
dispenser with water and add only then approximately 1
kg of salt (see chapter entitled Rinse aid and refined salt).
The water may overflow: this is normal and is not a cause
for concern. Select the water hardness value (see chapter
entitled Rinse aid and refined salt). - After the salt has been
poured into the machine, the LOW SALT indicator light*
switches off.
If the salt container is not filled, the water softener and
the heating element may be damaged as a result.

Technical data

Dimensions
Capacity
Water supply
pressure
Power supply
voltage
Total absorbed
power
Fuse
6
All manuals and user guides at all-guides.com
*
width 60 cm
height 85 cm
depth 60 cm
14 standard place-settings
0,05 ÷ 1MPa (0.5 ÷ 10 bar)
7,25 – 145 psi
See appliance data plate
See appliance data plate
See appliance data plate
This dishwasher conforms to the
following European Community
Directives:
-2006/95/EC (Low Voltage)
-2004/108/EC (Electromagnetic
Compatibility)
-2009/125/EC (Comm. Reg.
1016/2010) (Ecodesign)
-97/17/EC (Labelling)
-2012/19/EU Waste Electrical
and Electronic Equipment
(WEEE)
The machine has a buzzer/set of tones
dishwasher model
) to inform the user that a command has
been implemented: power on, cycle end etc.
The symbols/indicator lights/LEDs on the control panel/
display may vary in colour and may have a flashing or fixed
(depending on the dishwasher model)
light
The display provides useful information concerning the type
of wash cycle, drying/wash-cycle phase, remaining time,
temperature etc etc.
*
Only available in selected models.
(depending on the
.

Publicité

Table des Matières
loading

Table des Matières