General Information - Garland EFW400 Manuel

Table des Matières

Publicité

GENERAL INFORMATION

Unpacking
Carefully remove unit from carton. Remove all packing
materials, any protective material covering the stainless steel
should be removed immediately after the unit is installed.
Serial Plate Location
Electrical rating is shown on the serial plate and is readily
visible on the rear of the unit next to the power supply cord
inlet.
NOTE: Ensure electrical supply conforms with electrical
characteristics shown on the rating plate.
Safety
A qualified person must make the installation in
accordance with the authority having jurisdiction and
local codes.
This unit must only be operated by a qualified person. DO
NOT operate without reading this manual.
DO NOT operate this appliance unless all service and
access panels are in place and fastened properly.
DO NOT attempt to repair or replace any part of this
appliance unless all main power supplies have been
disconnected.
OPERATING INSTRUCTIONS
This appliance has been designed to have water in the tank
for even heating. Before first use it is recommended that the
inside of the tank be cleaned with a detergent soaked cloth,
to remove fabricating and protective oils. Rinse with clean
water and dry with a clean cloth.
1. Fill the tank with water so that the level is between the
minimum and maximum embossed lines on the inside
wall of the tank.
Page 2
All manuals and user guides at all-guides.com
WARNING
To avoid serious personal injury:
Wall Clearances
National Code Requirements
The installation and connection should comply with current
codes: In Canada - The Canadian Electrical Code Part 1 and
/ or local codes. In USA – The National Electrical Code ANSI /
NFPA – current edition.
2. Insert pan with a maximum depth not exceeding 4"
3. Plug appliance into electrical outlet.
4. Turn on appliance with green switch. The appliance will
DO NOT clean this appliance unless the power supply is
disconnected.
DO NOT immerse appliance in water.
USE EXTREME CAUTION in setting up, operating and
cleaning these appliances to avoid coming in contact
with hot surfaces. Suitable protective clothing should be
worn or proper utensils to prevent the risk of burns.
NOTE all warning labels and markings on this appliance,
which call attention to further dangers and necessary
precautions.
Back:
0
Sides:
0
(102mm)
heat the bath of water and maintain it at 130°F to 140°F
(54° C to 60°C).
Part # 3104500 Rev. 01 (01/29/08)

Publicité

Table des Matières
loading

Table des Matières