Using The Remote- Control; Trouble-Shooting - SilverCrest RC DP3 4001-A FR 3726 Instructions D'utilisation Et Consignes De Sécurité

Using the remote-
Q
control (fig. A)
The remote control will control up to 4
remote-controlled sockets (individually,
in groups or simultaneously).
1. Press the desired ON button of the
channel ON/ OFF button
C or D) on the remote control of
the device you wish to switch on.
The LED status light
erating control lamp
2. Press the desired OFF button of the
channel ON / OFF button
B, C or D) on the remote control for
the device you wish to switch off.
The LED operating status display
will go out.
3. Confirm the ALL ON / OFF button
to switch all remote-controlled
3
sockets simultaneously.

Trouble-shooting

Q
If the remote control does not
work, please check the follow-
ing points:
Prob- The operating indica-
lem tor
1
control device illumi-
nates but there is no
reaction
· Check if the battery still
Rem-
has sufficient Ampere. If
edy
necessary, install a new
battery.
284705_silv_Funksteckdosen-Set_IP20_Content_FR.indd 33
(A, B,
2
and the op-
5
will light up.
1
(A,
2
5
on the remote
Setting-up operation
Prob-
No indicator light
lem
on remote control
when pressing "ON"
or "OFF"
Rem- · Check if the battery is
inserted correctly.
edy
· Check if the battery has
good contact, if neces-
sary press down.
Prob- No reaction from
lem consumer
· Check that the appliance
Rem-
is switched on.
edy
· Assign a new code to the
wireless socket (see
"Setting up the wireless
socket").
· Check - by walking closer
to it - that the range is
correct for the desired
location.
1
GB 33
21.06.17 15:34