Video Recording - Aukey DR02 Mode D'emploi

To power on, insert the car charger into your car's 12V socket, then connect the included
cable to the car charger and to the Mini USB port of the DR02. Insert a Micro SD Card
into the Micro SD card slot and format it using the 'Format' option in Dash Camera 'Setup.'
After powering on each time, the system will start recording automatically. To power off,
disconnect the Mini USB cable.

Video Recording

● Loop Recording: Recording will begin automatically after powering on with a Micro
SD Card in the device. Each recorded file is up to ten minutes long, with old footage
being replaced when Micro SD Card storage is full.
● Motion Detection Recording: Switch on motion detection in 'Setup.' This function will
start recording video when the dash camera detects motion in front and stop recording
when motion is no longer detected.
● Time-Lapse Recording: Switch on time-lapse recording in 'Setup.' This function will
capture a picture per second to make a video played at 30fps.
Emergency Recording
● Manual File Backup
Press to back up the current file so that it will not be overwritten. A
appear in the top left of the LCD screen to indicate a protected emergency
recording is in progress.
● Auto File Backup
Once the G-sensor is activated by a sudden impact, the device will automatically
make a recording and protect it from being overwritten. Adjust G-sensor sensitivity in
the 'Setup' menu.
Snapshot
● Hold down
● The snapshot files are located in the \AUKEY\PHOTO folder on the Micro SD Card
● The icon will be shown after you take a snapshot. This will not interrupt the video
recording
Audio Recording
Turn on/off audio recording by long-pressing
adjusting in 'Setup' menu). When audio recording is on, in-car audio will be recorded
for 3 seconds to take a snapshot while in recording mode
- 05 -
when in recording mode (or by
icon will