Camp Chef PG24SG-2 Instructions Et Avertissements Pour L'installateur page 8

Hopper Clean-out Knob Assembly Installation
Hand tighten the hopper clean-out knob as shown inn Fig 16.
PG24-9 (1)
PULLOUT KNOB
FIG. 16
Burner Clean-out
Before each use the burner should be cleaned out by lifting
the pullout lock and pulling the clean-out port knob on the
right side of the grill to open the burner clean-out. This will
allow the ash from previous use to fall into the cup under
the grill. The cup should be removed and emptied and then
reinstalled before each use.
Never Operate the Pellet grill without the ash cup in place.
Make sure the burner clean-out port is closed and locked
before starting the grill.
Never open the burner clean-out port when the grill is hot.
After cleaning out the burner make sure to close the burner
clean-out by pushing the clean-out port knob in on the right
side of the grill. Make sure to lift the pullout lock and push
the clean-out port knob all the way in and lock in place
with the pullout lock. Every 50 hours of use, remove the grill
grates, grease tray, and heat deflector and clean the inside
FIG. 14
CLEANOUT PORT CLOSED
FIG. 15
CLEANOUT PORT OPEN
DANGER
COOKING GRATE
of the grill. If you notice a lot of ash blowing around in the
grill it is time to vacuum it out.
Filling the Auger Tube
Caution: Only use the feed setting when hopper has rUn
out of pellets. feed setting is not for normal use.
The first time you use your grill or any time the hopper has
ran out of pellets you will need to fill the auger tube. This
simply means you must fill the auger tube with pellets until
pellets reach the burner. This is done by turning the dial to
the FEED position and then holding in the bypass button
for 3 seconds. This will turn the auger on and the digital
readout will display "FEED". The auger will remain on for no
more than 7 minutes. This is ample time for the pellets to
reach the burner. It is easiest to open the burner clean-out
by pulling the knob on the right side of the grill. Once you
hear pellets dropping into the cup you can close the clean-
out port by pushing the knob on the right side of the grill
and then select your cooking temperature. (Never operate
grill without the ash cup in place). Always make sure the
burner clean-out port is closed by pushing in the knob on
the right side of the grill before selecting any of the cook
settings. Never open the burner clean-out port when the grill
is hot.
Emptying the Hopper
This grill is equipped with a hopper drain to quickly remove
the pellets from the hopper. This can be used to remove
pellets if the grill is being stored for a long time or to remove
pellets to change to a different flavor pellet.
Warning: Never remove the auger guard from the hopper
while the pellet grill is on. Never operate the grill without the
auger guard in place.
Caution: The instructions below must be followed when
emptying the hopper.
1. Unplug the grill from the power source.
2. Hang a bucket or use a box to catch the pellets that will
come out of the tube on the rear of the hopper.
3. Lift the pullout lock on the left side of the hopper and pull
the hopper clean-out knob.
4. Sweep the remaining pellets in the hopper towards the
drain hole using the included rake to reach through the
CLEANOUT PORT KNOB
guard.
5. Push in the hopper clean-out knob and lock in place using
the pullout lock.
6. Store the rake in the corner of the hopper as shown in Fig. 17.
CLEANOUT PORT OPEN