Install Handle - Camp Chef PG24SG-2 Instructions Et Avertissements Pour L'installateur

Assembly Instructions
Remove all loose parts from the inside of the grill and
hopper. Lay a blanket or piece of cardboard down to protect
the grill.
Attach the Legs
With the help of another person flip the grill upside down
on the blanket or cardboard. The grill lid and hopper lid will
swing open when doing this so be careful not to damage
the lids. The grill may also want to roll on its lid so one
person should hold the grill steady while the other person
assembles the bottom legs and wheels.
1. Assemble the legs as shown in Fig. 1. Finger tighten
hardware.
2. Assemble wheels to the legs as shown in Fig.2.
AXLE (1)
3. With the help of another person, stand the grill upright.
Be careful as the lid on the hopper and grill will close as
the grill is stood upright.
4. Tighten all hardware assembled in the previous steps.
Attach Chimney and Chimney Cap
1. Install chimney to grill as shown in Fig 3. Make sure to
install the gasket between the grill and the chimney.
2. Tighten all hardware.
3. Install 1/4-20 x 3 Bolt through chimney cap and secure
using Qty (1) 1/4-20 nut. Thread second nut onto bolt
leaving approximately 1.5" to the top of the cap. Thread
cap assembly down into the chimney bracket until the
lower nut hits the bracket. See Fig 3.
1/4-20 X 3 BOLT
1/4-20 NUT
M6 X 15 SCREW
4. The height of the chimney cap can be adjusted for
FIG.1
5. Tighten all hardware.

Install Handle

1. Install the handle as shown in Fig 4.
2. Tighten all hardware.
M8 X 20 BOLT (8)
M8 LOCK WASHER (8)
WHEEL AXLE (2)
WHEEL (2)
Install Hopper Handle
FIG.2
1. Install hopper handle as shown in Fig. 5.
FIG. 3
CHIMNEY GASKET
summer and winter. In the summer the gap should be
approximately 1-1/2". In the winter the gap should be
approximately ½".
FIG. 4
HANDLE
HANDLE DEFLECTOR
M6 HANDLE SCREW (2)
HOPPER HANDLE (1)
PGC24-12
ASH CUP
M6 FLAT WASHER
M6 LOCK WASHER
HANDLE BEZEL (2)
M6 RUBBER WASHER (2)
M6 FENDER WASHER (2)
M6 LOCK WASHER (2)
M6 X 15 BOLT (2)
FIG. 5
M6 NUT