Remote Control; Power Source - Electrohome 20EV701 Manuel D'instructions

All manuals and user guides at all-guides.com

Remote control

Inserting Batteries
1
Open the battery compartment
cover in the direction of the
arrow.
Operation
• Aim the remote control at the remote sensor and
press control buttons to operate.
• Operate the remote control within 30° angle on
either side of the remote sensor, up to a dis-
tance of Approx. 5 meters.
NOTES:
•
Do not leave the remote control unit exposed to direct sunlight or in hot or humid places.
• The remote control unit uses infrared beams to transmit signals, so sunlight or fluorescent light on the remote
sensor may shorten operating distance.
• Incorrect use of batteries may cause them to leak or burst. Read the battery warnings and use the batteries
properly.
• Do not mix old and new batteries.
• Remove batteries if the remote control will not be operated for an extended period of time.

Power source

AC Outlet
Wider Hole
and Blade
Polarized AC Cord Plug
(One blade is wider than the other.)
12
5N10721A_EN_P06-13
2
Install two "AAA" batteries
(supplied), paying attention to
the polarity diagram in the
battery compartment.
Approx. 5 meters
TO USE AC POWER SOURCE
Use the AC polarized line cord provided for operation on
AC. Insert the AC cord plug into a standard 120V 60Hz
polarized AC outlet.
NOTES:
• Never connect the AC line cord plug to anything other
than the specified voltage (120V 60Hz).
Use the attached power cord only.
• If the polarized AC cord does not fit into a nonpolarized
AC outlet, do not attempt to file or cut the blade. It is the
user's responsibility to have an electrician replace the
obsolete outlet.
• If you cause a static discharge when touching the unit, and
the unit fails to function, simply unplug the unit from the wall
outlet, wait a few minute and plug it back in. The unit should
return to normal operation.
12
(continued)
3
Replace the compartment
cover.
4/25/05, 17:24