Bosch HDC300 Consignes De Sécurité/D'utilisation page 5

161992A079-HDC300_HDC300 1/10/14 1:06 PM Page 5
For extra long chisels, the HDC300 comes with
an extension tube. Remove the rubber bumper
from the housing. Install the extension tube by
FIG. 7
Insert the vacuum hose from the vacuum
into the dust port of the dust extraction unit
(Fig. 9).
The Bosch vacuum hose comes with a
sleeve nozzle attached to a snap-in
connector (Fig. 9). The sleeve nozzle
provides the quickest, easiest connection of
the nozzle to the attachment. The snap-in
connector provides a more secured
connection.
To use the snap-in connector, remove the
sliding the wide opening onto the housing end.
Re-install the rubber bumper onto the tip of the
extension tube (Fig. 8).
rubber nozzle from the vacuum hose. Press
the snap-in connector into the dust port until
you hear the click.
Dust port adaptors are also available to
connect the Bosch
attachment to any common size vacuum
hose. See Boschtools.com for details.
Turn the vacuum on and place the tool /
attachment over the desired chiseling
location. Follow all tool safety and operating
instructions.
-5-
EXTENSION
RM
dust extraction