Description And Connection Of Connectors; Connector Locations And Functions - THOMSON OCP 42 Manuel D'utilisation

108

1.3 - DESCRIPTION AND CONNECTION OF CONNECTORS

1.3.1 - Connector locations and functions

Note: The OCP 50 connector functions used with a MSP (centralized system) is
described in the MCP user manual.
150 Ohms impedance on/
off. If there are no panels
connected to the LOOP
connector, this switch
should be set to 150 Ohms.
Inter-panel data input/out-
put.
* NOTE:The OCP must be connecting with the ground installation
THOMSON OCP 42/OCP 50
User manual
Chapter 1 - OCP 42/OCP 50 Installation

Description and connection of connectors

PREVIEW / AUX J3
LOOP 150W
LOOP J2 J1
CCU
DC IN 12V
PREVIEW input/output
Auxiliary data input
Ground connecting*
OCP/CCU or OCP/CAM
data input/output.
Panel power supply
(10.5 to 17 Volts).
B1500M24LA
September 2000