Tail Assembly - Rutland FM910-4 Manuel Du Propriétaire

Rutland Furlmatic 910-4 Windcharger
Fig. 4

Tail Assembly

Fig. 5
Fig. 6
Doc No: SM-138 Iss. D 16.03.15
5. Fit the plastic nose dome in position on the
front of the generator hub and secure in place
with the three nylon screws provided. (Fig.4)
Recheck the tightness of all screws in a few
weeks time as loosening is possible.
Alternatively the blades, tail and nose dome
can be fitted after mounting the generator
assembly to the tower.
Fit the tail fin on to the hinge assembly using
the screws and washers already present
(Fig's 5 and 6)
Do not remove the silicone protectors from
the tail stops!
NB. The tail fin is set at an angle
of 15° from vertical. This is vital to
the furling mechanism and should
not be altered.
For the effective operation of the
furling system the wind turbine
must be sited to ensure it is as free
as possible from turbulence and the
tower is in a stable, upright
position.
9
Installation & Operation
Marlec Eng Co Ltd