Using The Demo Mode; Using The Remote Control; Installing The Batteries - Canvas 064-4017-6 Instructions De Montage

USING THE DEMO MODE

For use in retail store.
To turn Demo Mode on, press and hold the timer button (3) for 10 seconds until the
display (1) shows "00". Demo Mode deactivates the heater and all front control panel
buttons except the flame control button. To turn Demo Mode off, press and hold
the timer button (3) for 10 seconds until the display (1) shows "L4". This fireplace is
shipped with Demo Mode turned off for normal customer usage
1

USING THE REMOTE CONTROL

INSTALLING THE BATTERIES

When replacing batteries, use AAA batteries.
1. Press down and slide back cover off the battery compartment.
2. Insert two provided AAA batteries into the battery compartment making sure that
the ends of the batteries with the negative (-) symbols are against the springs in the
battery compartment.
3. Replace the battery compartment cover, making sure it snaps into position.
4. Turn the remote over and aim it towards the fireplace/heater unit.
5. Press the power button on the upper left, and see if the flames on the fireplace/heater turn on or
off.
6. If nothing appears to happen, check to make sure the batteries are installed correctly, and try
again.
All manuals and user guides at all-guides.com
3
ASHCROFT MEDIA FIREPLACE
43