Canvas 064-4017-6 Instructions De Montage page 41

Masquer les pouces Voir aussi pour 064-4017-6:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

To set the thermostat temperature: Turn on the heater, then press and hold the heater
button (4) for five seconds to enter temperature adjustment mode. The LED function
indicator (2) is red if using Fahrenheit and green if using Celsius. In adjustment
mode, the display (1) flashes (interval is 0.5 second). The temperature setting range
is between 62 to 82ºF (17 to 27ºC). In adjustment mode, press the heater button
multiple times until you reach your preferred temperature setting. After you release
the heater button, your preferred temperature will be flashing. Once it stops flashing,
and the display goes dark, the thermostat will be set at your preferred temperature
(and kept in memory).
To lock the heating function in the OFF position, with the main power button on, press
and hold the heater button (4) for ten seconds. The log lights flash several times to
indicate that the heater function is locked. In this mode, there is no heating function but
only glowing logs and normal flame control operation.
To unlock the heating function, press and hold the heater button (4) for ten seconds.
The log lights flash several times and then normal heating function mode is turned on.
NOTE: The heater default temperature is set to 72ºF (22ºC). If your ambient room
temperature is above 72ºF (22ºC), then your heater will automatically shut off after
few minutes. Adjust your heater thermostat (see below) to a higher temperature in
order to keep your heater ON above 72ºF (22ºC).
1
USING THE FLAME CONTROL
Press the flame button (5) to set the flames for different levels of flame brightness.
These flame levels are shown in the display (1). The flame settings are as follows:
Button Press
Flame Level
1st press
High
2nd press
Medium
3rd press
Low
4th press
Flames Off
5th press
All Off
Regardless of the previous flame setting, when powered off by the main power
button, the flames will come on in L4 mode (High) when you turn the heater on.
All manuals and user guides at all-guides.com
2
Display Value Fireplace Appearance
L4
L3
L2
L1
None
4
Flames Highest, Logs Glow Highest
Flames Medium, Logs Glow Medium
Flames Low, Logs Glow Low
Flames Off, Logs Glow Highest
Flames Off, Logs Off
ASHCROFT MEDIA FIREPLACE
6
41

Publicité

Chapitres

Table des Matières
loading

Table des Matières