Sunny Health & Fitness BELT DRIVE Mode D'emploi page 16

ADJUSTMENTS & USAGE GUIDE
ADJUSTING THE BALANCE
In order to achieve a smooth and comfortable ride, you must ensure that the
bike is stabled and secured. If you notice that the bike is unbalanced during
use, you should adjust the Foot Levelers (No. 74) located beneath the front
and rear stabilizers. To do so, simply rotate the Foot Leveler (No. 74) until
the bike becomes level with the floor surface. If required, repeat this process
74
to adjust the remaining Foot Levelers (No. 74).
ADJUSTING THE TENSION & EMERGENCY STOP
Adjust the tension by rotating the Tension Control Knob (No. 15) clockwise
15
to increase the level of resistance. Rotate the Tension Control Knob (No.
15) counter-clockwise to decrease the level of resistance. Push down on the
Tension Control Knob (No. 15) to enforce the brake and stop the bike
immediately.
ADJUSTING THE ANGLE OF SEAT
#88
Use Spanner (No. 88) to unscrew the nut under the seat. Adjust the seat to
S 14
the desired angle and reinstall the nut. Check the nut periodically to ensure
that it is tight and secure. Use the Spanner (No. 88) to tighten when
necessary.
Note: You will need to tighten the nut on the opposite side at the same time.
The use of an additional spanner is required.
MOVING THE BIKE
To move the bike, first ensure that the handlebar is properly secured. If the
handlebar is loose, tighten the Adjustment Knob (No. 38) to secure it. Next,
stand at the front of the bike so that you're directly in front of the handlebar.
Firmly grasp and hold each side of the handlebar, place one foot on the
Front Stabilizer (No. 73), and tilt the bike towards you until the
transportation wheels on the Front Stabilizer (No. 73) touches the ground.
With the transportation wheels on the ground, you can transport the bike to
the desired location with ease.
ADJUSTING THE HEIGHT
I II
Loosen and pull out the Adjustment Knob (No. 38) to adjust the height of
36
the seat. You may also slide the seat forward or backwards by loosening and
36
pulling out the Adjustment Knob (No. 38) on the Seat Slider (No. 36). You
38 38
38
38 may adjust the height of the handlebar by using the Adjustment Knob (No.
38). When adjusting, you will see a limit on the seat post, seat slider, and
handlebar post. Do not lift the posts passed this mark. Always check the
Adjustment Knob (No. 38) to ensure that it is fully secured when you finish
making an adjustment.
15