Sunny Health & Fitness BELT DRIVE Mode D'emploi page 12

We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY (877-
907-8669).
#90L/R 9/16*20*H8*S22 2PCS
#71 D5*φ13*1 2PCS
#72 M5*15*φ10 2PCS
15
85
92L
45L
90L
45L
92L
S15
88
90L
92L
89
S22
S15
88
S22
#89
S15
#88
70
71
71
45R 92R
90R
45R
92R
S15
88
90R
92R
89
S22
88
STEP 4:
WARNING! Read instructions carefully as improper
assembly may cause permanent damage to your
bike.
Note: The Pedals (No. 92L/R) are marked "L" and
"R" for Left and Right.
Remove the 2 Nylon Nuts (No. 90L/R) located on the
Pedals (No. 92L/R).
72
Turn the
CLOCKWISE as tightly as you can with your hand.
Align the Left Pedal (No. 92L) with the Left Crank
(No. 45L) at 90°. Turn the pedal bolt on the Left Pedal
(No. 92L) COUNTER-CLOCKWISE as tightly as you
can with your hand. Then, use Spanner (No. 88) to
tighten and secure.
Turn the Left Nylon Nut (No. 90L) CLOCKWISE as
tightly as you can with your hand. Use Spanner (No.
88) to hold the pedal bolt on the Left Pedal (No. 92L)
and use Spanner (No. 89) to turn the Left Nylon Nut
(No. 90L) CLOCKWISE at the same time, until it is
tightened on to the Left Crank (No. 45L).
Align the Right Pedal (No. 92R) with the Right Crank
(No. 45R) at 90°. Turn the pedal bolt on the Right
Pedal (No. 92R) CLOCKWISE as tightly as you can
with your hand. Then, use Spanner (No. 88) to
tighten and secure.
Turn the Right Nylon Nut (No. 90R) COUNTER-
CLOCKWISE as tightly as you can with your hand.
Use Spanner (No. 88) to hold the pedal bolt on the
Right Pedal (No. 92R) and use Spanner (No. 89) to
turn the Right Nylon Nut (No. 90R) COUNTER-
CLOCKWISE at the same time, until it is tightened on
to the Right Crank (No. 45R).
Remove 2 Screws (No. 72) and 2 Washers (No. 71)
from the Main Frame (No. 85) using Spanner (No.
88). Attach the Water Bottle Holder (No. 70) to the
Main Frame (No. 85) using the 2 Screws (No. 72)
and 2 Washers (No. 71) that were removed. Tighten
and secure with Spanner (No. 88).
11
Tension Control Knob (No. 15)