Changing The Tools - Robland LBM Serie Mode D'emploi

Changing the tools

• To change tools (A) the machine must be stationary and disconnected from its power supply.
• Remove the protective hood (E) by unscrewing bolts (F).
• Loosen the clamping nut (D) with keys (B, C) so far until the collet becomes loose and the tool
(A) can easily be removed from the chuck.
• Remove the tool from the collet chuck.
• Always clean clamping component and tool before use. Make sure all clamping surfaces
are free from dirt, oil, grease and water. Do not use fibre materials, such as cotton waste for
cleaning.
• Damage to the tool, to the cutting edges and to the knife clamping systems as well as to the
clamping adaptors due to loss of of clamping forces.
• Check the shank diameter of the new tool and verify that it meets the nominal range of the
collet size.
• Put the shank of the new tool into the connecting bore of the collet chuck.
• Attention! The collet has to be placed in the collet nut before it is repositioned on the chuck.
• Do not re-install neither damaged or modified clamping adaptors and tools with corroded screw
connections.
• Tighten screw to the required torque before each use (Fig 5).
• Make sure the minimum required clamping lenght according to shank diameter is maintained.
• Attention! Never tighten an empty collet.
Instructions for collet change
• Remove the collet from the clamping nut by lateral pressing.
• Put the clamping nut on a flat even surface and put the new collet slightly tilted onto the
clamping nut. Click now the collet -by pressing from top- into the clamping nut.
Fig.4
Fig.5
42
Nederlands
(fig 4-5-6)
Français
Fig.6
English Deutsch
V0815 LBM