Operating Instructions; Connecting Power; Battery Backup; Installing The Battery - Electrohome SelfSet EAAC601 Guide De L'utilisateur

Connecting Power

The SelfSet Clock Radio is equipped with an "auto time set" feature. When
™
power is connected, the clock display will flash '2' which is TIME ZONE 2
(Eastern time) and the default TIME ZONE setting.
To select TIME ZONE 2 (Eastern time) as your default time zone:
• Press ONCE to confirm your selection.
• The correct time will be displayed, unless you are in another time zone.
To change your time zone upon setup:
• Press or
ONCE to confirm your selection.
To change your time zone after setup:
• With the radio off, press and hold the
zone numbers flash.
• Press or
ONCE to confirm your selection.
There are 8 programmed times zones:
0 - Newfoundland time
1 - Atlantic time
2 - Eastern time (default)

Battery Backup

This alarm clock is equipped with a battery backup feature. This feature will
restore your alarm clock settings in the event of a power outage. The 3V,
CR2032 Flat Lithium battery is pre-installed at the factory, however, should you
need to replace the battery, please read the following instructions.

Installing the Battery

1. Using a small Phillips Head screwdriver, loosen the screw from the battery
panel on the bottom of the unit.
2. Remove the battery compartment panel.
3. Remove/properly dispose of depleted battery and replace with new, 3V,
CR2032 Flat Lithium battery.
4. Close the battery compartment and put screw into place to secure battery panel.
All manuals and user guides at all-guides.com

OPERATING INSTRUCTIONS

until your own time zone appears on the display; press
until your own time zone appears on the display; press
3 - Central time
4 - Mountain time
5 - Pacific time
6 - Alaska time
7 - Hawaiian time
6
button until the time