Back/Bottom; Operating Instructions; Connecting Power; Battery Backup - Electrohome CR35 Manuel De L'utilisateur

PRODUCT INFORMATION

BACK/BOTTOM

1
2
3
4 5
1. Speaker
2. Air vents
3. Battery compartment for 1 x 3V,
CR2032 Flat Lithium battery
- 10 -
All manuals and user guides at all-guides.com
6
4. FM Antenna
5. Indoor Temperature Sensor
6. AC Power Supply

OPERATING INSTRUCTIONS

CONNECTING POWER

The Retro Alarm Clock Radio is equipped with an "AUTO TIME SET" feature. When power is connected,
the clock display will flash '2' which is TIME ZONE 2 (Eastern time) and the default TIME ZONE setting.
To select TIME ZONE 2 (Eastern time) as your default time zone:
• Press ONCE to accept that time zone.
To change your time zone upon setup:
• Press / until your own time zone appears on the display; press
your selection.
There are 8 programmed times zones:
Zone 0 - Newfoundland time
Zone 1 - Atlantic time
Zone 2 - Eastern time (default)
Zone 3 - Central time
Zone 4 - Mountain time
To change your time zone after setup:
• Press and hold the
• Press / until your own time zone appears on the display; press
your selection.

BATTERY BACKUP

This alarm clock is equipped with a battery backup feature. This feature will restore your alarm clock
settings in the event of a power outage. The 3V, CR2032 Flat Lithium battery is pre-installed at the
factory, however, should you need to replace the battery, please read the following instructions.
ONCE to confirm
Zone 5 - Pacific time
Zone 6 - Alaska time
Zone 7 - Hawaiian time
button until numbers flash.
ONCE to confirm
- 11 -