Toparc 054165 Guide Rapide page 3

Translation of the original instructions
ADJUSTMENT OF THE DEPTH OF THE CUT
A minimum amount of material should be cut in order to separate the laser welded components. It is not necessary to
cut the total thickness of the panel to separate them. To adjust the depth of the cut, tighten the adjustment screw (1)
until the bottom plate comes in contact with the motor assembly (photo left). Then loosen the clamp cap screw (2), to
release the motor assembly and move it forward (3) until the cutter is at the level of the bottom plate. Then unscrew
the screw (1) until the cutter comes off 0.80mm from the bottom plate. This sets the depth of the cut.
Use the provided key to adjust the position of the
bottom plate
ADJUSTMENT OF THE CUTTER SPEED
This adjustment is possible by adjusting the air valve under the product (see below). Beware ! It is important to set
cutter speed correctly, in order not to make the cutter overheat during the cutting, which would cause melting of the
material to be cut, and clog up the cutter, not allowing it to cut correctly.
INSTRUCTIONS OF USE
The direction of the cut should always be at right angle to the cutter. Use the edge of the car body as a guide if ne-
cessary, to cut in a perfect straight line.
LASER CORD SHEET CUTTER
1
The cutter should come off 0.80mm from the bot-
tom plate.
EN
2
3
3