Krups XP52 Serie Manuel D'utilisation page 64

English
Problems
Crackles are heard
in the filter holder.
The pump is
unusually noisy.
The cups are not
filled equally.
The machine leaks
on the sides of the
filter holder.
Your espresso tastes
bad.
The appliance does
not work
The steam nozzle
does not froth the
milk.
12. END-OF-LIFE ELECTRONIC PRODUCT
Environmental protection first!

Your appliance contains a lot of recoverable or recyclable material.

When disposing of it, take it to a local civic waste collection point.
60
Possible causes
Normal phenomenon:
the filter holder security lock.
No water in the tank.
Tank poorly fitted.
The filter holder is clogged.
The filter holder has not
been properly positioned.
The edge of the filter holder
is clogged by ground coffee.
Pod poorly positioned in the
filter.
After descaling, the rinsing
was not performed properly.
The pump was unprimed
due to lack of water.
The detachable water tank is
not properly clicked in place.
The Claris cartridge has
been replaced but not
primed.
The steam nozzle is blocked
or scaled up.
The milk is not cold or not
fresh enough.
The shape of the container
is not appropriate.
Solutions
Stop the appliance, fill the water tank and turn the
machine back on.
Press down firmly on the tank.
See paragraph 8.
Put the filter holder in place and lock it (by turning
it to the right as far as it will go, up to the stop).
Remove excess coffee.
Place all the paper inside the filter holder.
Rinse the device according to the manual (see
paragraph 9).
Fill the water tank and reprime the pump (see
paragraph 5). Avoid completely emptying the tank.
Click the tank into place by pressing firmly.
See paragraph 5.
Descale the steam nozzle (see paragraph 9) or
unblock it with a needle.
Use fresh, cold milk. Try using a different brand of
milk.
Use a small pitcher.