Starting And Stopping The Machine; After Use; Using The Machine - Garland CHOPPER 452 ZE Manuel De L'utilisateur

English
Check that there are no oil leaks in the machine. If you
detect leaks bring your machine in for service.

5.3.3. STARTING AND STOPPING THE MACHINE

1. Loosen the bleed screw until
the air can enter and exit the oil
tank without problems. The flow
of air that out through the bleed screw hole should be
detectable during operation of the appliance. If you do
not loosen the bleed screw, the air inside the hydraulic
system cannot leave, thus compressing itself with
every cutting motion of the bandsaw. This air pressure
can damage the hydraulic system's seals, causing
permanent damage to the machine.
2. Turn on the engine by pressing the green button.
Note: When the temperature is low, let the bandsaw
run idle for approximately 15 minutes so that the oil
heats to the right temperature.
5.3.5. CHECKPOINTS AFTER COMMISSIONING
It is important to pay attention to the possible loose
parts or the temperature of the machine. If you
detect any anomaly in the machine immediately stop
and check it carefully. In case of any malfunction or
problem take the machine for service for repaired.
Under no condition should you continue to use the
machine if the operation does not seem appropriate.
All manuals and user guides at all-guides.com
5.3.5.1. VERIFICATION OF THE SECURITY SYSTEM
Check that the safety system works correctly by a
testing of the machine without a trunk. To do this,
switch on the engine by pressing the switch and
pushing both the hydraulic control levers at the same
time, the blade will begin its cutting motion. While the
blade is moving stop pressing the left lever and blade
should stop and move back to its original position.
Then perform the same test operation.
If after the test you detect that the machine does
not function as described in this point do not reuse
the machine until it has been reviewed by a service
technician.
5.3.5.2. LEAK VERIFICATION
Check that there are no oil leaks in the machine. If you
detect a leak, take your machine in for service.

5.4. AFTER USE

Once you have stopped using the machine:
1. Disconnect the power source of the machine by
pressing the switch in position "O".
2. Unplug the machine.
3. When you stop using the machine tighten the
bleed screw to prevent oil leakage from the
bandsaw through the trap.

6. USING THE MACHINE

Use this machine only for the designated
purposes. Using this chainsaw for any other use is
dangerous and can cause bodily harm and/or damage
to the machine.
Never force the bandsaw for more than 5 seconds
by pressing on a trunk too hard. After this interval,
34/120