Preparing Kitchen Units; Preparing The Appliance For Installation - Gaggenau AR 410 710 Manuel D'installation

Preparing Kitchen Units

The fitted unit must still be sturdy after the cut-outs have
been made.
Make the cut-out in the base plate as shown in the
installation drawing.
After making the cut-outs, remove any shavings.
Exhaust opening in the cabinet base panel
Provide an air outlet in the cabinet base panel, minimum
cross-section approx. 110 square inches (700 cm²).
Make the exhaust opening in the cabinet base panel as
large as possible in order to keep drafts and noise to a
minimum.
8
P r e p a r i n g K i t c h e n U n i t s
Preparing the appliance for
installation
P r e p a r i n g t h e a p p l ia n c e f o r in s t a l la t i o n
NOTICE: The filters must be removed for cleaning on a
regular basis.
The filters come preinstalled in the appliance and can
only be taken out from one side. If required by the
installation situation, you can fit the filters on the
opposite side so that they are still accessible following
installation.
1 Loosen the screws on the filter covers on both
sides . Remove the filter covers
(A)
2 Carefully remove the filters with both hands
NOTICE: The activated charcoal filters are heavy.
Do not drop them – this may cause parts of the filter
to break off.
3 Insert the filter on the opposite side. Secure each
one using three straight-knurled nuts.
4 Use three straight-knurled nuts to secure each filter
cover to the filter openings that are not in use.
.
(B)
.
(C)