Connect Appliance; Networked Operation; Removing The Appliance - Gaggenau AR 410 710 Manuel D'installation

Connect appliance

1 Use the control cable to connect the remote fan unit
and the fan. The plug must snap into place.
2 Plug the remote fan unit's mains plug into the
grounded socket.
Note: Do not kink or trap the connection cable, or
route it over sharp edges.
3 Check that the appliance works. If the appliance
does not work, check that the control cable is
correctly positioned.

Networked operation

Several appliances can be networked together. The light
and blower on each of the appliances are operated
synchronously.
Connect the appliances in series via the connector
sockets X1 and X2 (equal value). The sequence of the
networking does not have any effect. If the enclosed
network cables are too short, use a commercially
available network cable (min. Cat. 5, shielded).
Maximum number of networked appliances: 20. Total
length of all of the network cables: 131 feet (40 m).
During the initial installation, a qualified electrician
must check that the system functions correctly.
If one of the networked appliances fails (power
interruption, network cable disconnected), this leads to
the blower function being blocked for the entire system.
All of the buttons on the appliance flash.
When changing the configuration, the system must be
re-initialized:
1 Unscrew the cover plate.
2 Press and hold the reset button until both LEDs
light up continuously (approx. 5 seconds). Then
release the button within 5 seconds.
3 Screw on the cover plate.
4 After initialization, have a qualified electrician
check that the system functions correctly.

Removing the appliance

Disconnect the appliance from the power supply.
Remove the control cable. Undo the exhaust
connections. Pull out the appliance.
11