1
DC 12V in
2
DIN connector (see below)
3
Video 1 input
4
Video 2 input
5
Video output connector
6
power indicator
7
detect indicator
8
SD card slot
9
power ON/OFF switch
6. Installation
Refer to the illustrations on page 2 of this manual.
•
Insert a suitable SD card into the card slot [8]. Make sure the overwrite protection is not enabled.
•
Connect the cameras (not incl.) to the video inputs [3, 4]. It is possible to power the cameras via
the DIN connector. Insert the DIN cable into the connector [2] and connect one of the red power
plugs to the camera.
Note: max. Current is 600mA through both plugs, so either connect two cameras each requiring
max. 300mA or one camera that draws max. 600 mA.
•
When the cameras support sound, connect the appropriate audio inputs via the DIN cable: connect
audio from video 1 to the yellow RCA, from camera 2 to the red RCA.
•
Connect a monitor (not incl.) to the video output connector [5]. When applicable, also connect the
audio out connector from the DIN cable (white RCA) to the monitor. The monitor needs its own
power supply.
•
Connect the included power adaptor to the 12Vdc input [1] and plug the adaptor into a suitable
mains outlet.
•
Switch the power switch [9] to the ON-position. The power indicator [6] lights up.
7. Menu overview
Press the MENU button [15] to enter the on-screen menu.
•
Use the UP [14], DOWN [18], LEFT [16] and RIGHT [17] buttons to navigate through the menus.
•
Press OK/SHOT [15] to enter a submenu or accept a setting.
•
Photo 1
Photo 3
Manual capture
Movie
Movie clip
EXIT
Auto capture
Master capture
Auto capture
Movie prerecord
File overwrite setting
EXIT
22.09.2011
All manuals and user guides at all-guides.com
capture 1 picture
capture 3 pictures
start/stop recording 1 AVI video
start/stop recording short AVI videos (1 minute)
On
Off
EXIT
Photo 1
Photo 3
Movie 5s
Movie 10s
EXIT
Movie 5s
Movie 10s
Off
EXIT
On
Off
EXIT
DVRSD1
10
MODE button
11
DISP button
12
SHOT button
13
ZOOM button
14
UP button
15
MENU/OK button
16
LEFT button
17
RIGHT button
18
DOWN button
switch auto-capture function on
switch auto-capture function off
auto-capture 1 picture
auto-capture 3 pictures
auto-capture 5s movie
auto-capture 10s movie
set pre-record time to 5s
set pre-record time to 10s
no pre-recording
overwrite files when SD card is full
stop when SD card is full
4
©Velleman nv