VS RondoLift Mode D'emploi page 11

(1)
4. Barrel shape.
Optionally a lockable drawer on the left, on the right, or on
the left and right (1).
Optionally with cable conduit (5) or power supply chain (2).
To complete the cabling, move the table into the uppermost
position.
Cabling in the power supply chain
- Pull out the drawer on the cabling side.
- Unclip the power supply chain from the drawer (8).
- Unscrew the 4 knurled screws (3) at the cable deflector
guide.
- Press the cable into the power supply chain. (Impor-
tant: Only leave as much cable as is necessary at the
bottom.)
- Clip the power supply chain to the drawer (8).
- Reinstall the cable deflection guide with the 4 knurled
screws.
- Release the strain-relief device (8) at the bottom with
a Phillips screwdriver.
- Insert the cables and screw down at the bottom at the
strain-relief device (4).
(8)
(2)
(4)
(1)
(5)
(3)
(2)
Cabling in the cable conduit
- Pull out the drawer.
- Insert the cable into the cable conduit.
- Secure cable in the drawer at the strain-relief device (6).
- Coil the cable conduit on the mounting (7).
(6)
(7)
(1)
11