Useful Hints - ROBLIN MISTRAL 800 Notice D'utilisation Et D'installation

IMPORTANT - The wires in this mains lead are coloured in accordance with the following code :
green / yellow : earth
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows.
- The wire which is coloured green and yellow must be connected to the terminal in the plug which is
marked with the letter E or by the earth symbol
- The wire which is coloured blue must be connected to the terminal which is marked with the letter N
or coloured black.
- The wire which is coloured brown must be connected to the terminal which is marked with the letter
L or coloured red.
ATTENTION: Do not forget to use adequate plugs to the support brackets. Enquire after the manu-
facturers. Do an embedding if necessary. The manufacturer accepts no responsibility in case of a
faulty hanging due to the drilling and the setting up of plugs.
The Outside Wall Aspiration has to be fitted outside, but it must under no circumstances be fitted
inside.
To achieve efficient installation and low level of noise, it is convenient to provide a distance from
3 to 6 meters between hood outlet and mistral motor.
a)Define the place of the appliance according to position of the hood or of the capteur.
b)Pierce a hole in the wall at the place where the appliance is to be positioned according to figure n°2.
c)Unscrew the 2 hex domed nuts of the appliance cover and remove it
d)Fit the element 300 mm long of the telescopic sleeve onto the appliance flange
e)Bring the power cord through into the telescopic tube Ø 20 mm.
f)Position the appliance in the wall and orient it so that the gratings present themselves to the low.
g)Attach the appliance on the wall using stainless-steel screws and dowels.
h)Put the cover of the appliance bock in place and screw the 2 hex domed nuts.
i)Seal the telescopic sleeve froon inside.
j)Connect up the flexible tube diameter 200 mm to outlet of the capteur and to the sleeve of the appliance
for Outside Wall Aspiration. Comply with this diameter and number of bends to the minimum, so as to
ensure good air flow.
k)Connect up the power cord of the appliance for Outside Wall Aspiration on the 6 - way connectorby
observing figure n° 3.
l)Connect the electrical plug of the cord of the appliance for Outside Wall Aspiration on the capteur
oron the cooher hood without motor.
4

USEFUL HINTS

• To obtain the best performance we recommend you to switch 'ON' the cooker hood a few minutes (in
the boost setting) before you start cooking and you should leave it running for approximately 15 minutes
after finishing.
• IMPORTANT: NEVER DO FLAMBÉ COOKING UNDER THIS COOKER HOOD
All manuals and user guides at all-guides.com
blue : neutral brown : live
or coloured green or green and yellow.
GB
5