Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
3. Assembly of the front load bar:
Insert the piece (17) between the left (16) and right (18) sections of the front
bar and secure them with the corresponding bolts (5).
4. Assembly of the torsion bars and arms:
Install the arms on the torsion bar and fasten the adjustable screw (22) in
the support destined for this purpose at the recommended distance (L), as
can be seen in the figure.
!! DO NOT UNLOCK THE PLASTIC OR THE ARM PROTECTIVE
CLOTH UNTIL THE AWNING IS COMPLETELY INSTALLED.
!! THE SCREWS MUST BE TIGHTENED AT THE END OF THE
ASSEMBLY
Recommended distance (L):
30 cm for canopies of 3x2 m · 50 cm for canopies of 4x2,5 m
Publicité
Table des Matières
