Replacing The Lamp - ARTHUR MARTIN AMN2001AOW Notice D'utilisation

10
Problem
Water flows on the floor.
The temperature in the appli-
ance is too low/too high.
There is too much con-
densed water on the rear wall
of the refrigerator.
Door does not open easily.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
All manuals and user guides at all-guides.com
Possible cause
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are stor-
ed at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
There is no cold air circula-
tion in the appliance.
Door was opened too fre-
quently.
Door was not closed com-
pletely.
Stored food was not wrap-
ped.
You attempted to re-open
the door immediately after
closing.
Solution
Make sure that food prod-
ucts do not touch the rear
plate.
Attach the melting water out-
let to the evaporative tray.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces-
sary.
Make sure that there is cold
air circulation in the appli-
ance.
Open the door only when
necessary.
Make sure the door is closed
completely.
Wrap food in suitable pack-
aging before storing it in the
appliance.
Wait a few seconds between
closing and re-opening of the
door.

Replacing the lamp

The appliance is equipped with
a longlife LED interior light.