Moulinex cookeo touch Mode D'emploi page 31

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
The lid won't open
when steam is released:
The locking rod
is still in the upwards position.
Check that all of the steam
has been released
and wait until the Cookeo Touch
has cooled down fully.
The light
on the lid handle
no longer lights up:
The LED is not working.
Take the device
to an Approved Service Centre.
58
The screen does not light up:
The Cookeo Touch is not plugged in.
Ensure that the Cookeo Touch
is plugged in
correctly.
The Cookeo Touch is on standby.
Press the dot on the screen.
The inner metal lid cannot
be removed:
The ball lid is positioned incorrectly:
Unscrew the nut on the lid,
remove the inner part of the lid
by pulling it towards you,
access the ball cover,
correctly reposition the
lid.
Cookeo Touch error codes
There are several error codes:
• error 1
error communicating
with the keypad.
• error 2
error communicating
with the Wi-Fi.
• error 3
error communicating
with the power board.
If the temperature sensor
fails,
04, 05, 06, 07, 08,
the numbers
09
are displayed on the Cookeo
Touch.
• error 10
heating error.
• error 11
pressure problem.
Unplug the Cookeo Touch.
Ensure that all elements
of your Cookeo Touch
are in good condition.
If needed, clean the elements
of your Cookeo Touch
following the cleaning
instructions.
Ensure that the valve cover
is correctly in place.
• error 13
excess pressure.
• error 14
low pressure
due to lack of water:
- add water to the bowl,
- resume cooking.
59

Publicité

Table des Matières
loading

Table des Matières