Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Danger!
• Handle a damaged or leaking battery with
extreme care and dispose of it immediately as
per regulations. Wear gloves for this.
• If you come into contact with battery acid,
wash the affected area with soap and water.
If battery acid gets into your eye, rinse it out
with water and seek medical treatment imme-
diately!
• The terminals must not be short-circuited.
Replacing the batteries
WARNING! Follow these instructions to
avoid mechanical and electrical dam-
age.
Insert the included batteries in the product
before the first use.
Inserting the batteries in the remote
control (Fig. B)
1. Use a suitable screwdriver to loosen the screw
(1a) on the battery holder (1c) on the under-
side of the remote control (1).
2. Remove the lid (1b) and carefully place two
batteries (5) into the battery holder (1c). The
batteries must fit fully into the battery holder.
Note: Pay attention to correct plus/minus polar-
ity of the batteries and their installation.
3. Screw the lid (1b) tightly onto the underside.
Inserting the batteries in the locomotive
(Fig. C)
1. Use a suitable screwdriver to loosen the screw
(2a) on the battery holder (2c) on the back of
the locomotive (2).
2. Remove the lid (2b) and carefully place two
batteries (5) into the battery holder (2c). The
batteries must fit fully into the battery holder.
Note: Pay attention to correct plus/minus polari-
ty of the batteries and their installation.
3. Screw the lid (2b) tightly onto the back.
All manuals and user guides at all-guides.com
Replacing battery
WARNING! Follow these instructions to
avoid mechanical and electrical dam-
age.
If the batteries stop working, replace them using
the same process as described for inserting
them. Remove the batteries already in the prod-
uct before inserting the new batteries.
Remote control
To control the locomotive with the remote con-
trol, the remote control (1) and the locomotive
(2) must be set to the same channel.
1. Set the control lever (1f) on the remote control
to A or B (Fig. F).
2. Set the control lever (2d) on the locomotive to
the same setting as the remote control, either
A or B (Fig. F).
Note: The locomotive is off when the control
lever is in the OFF position (Fig. E).
Activating the remote control
In order to control the locomotive with the
remote control, the infrared receiver on the
locomotive must be activated.
1. Insert the batteries into the remote control (Fig.
B) and the locomotive (Fig. C).
2. Set the remote control and the locomotive to
the same channel, as described above (Fig.
F).
3. Press any button on the locomotive (2e-2g)
to activate it. Only then will the locomotive
be able to receive the signal from the remote
control (Fig. G).
Note: After five minutes of inactivity, the prod-
uct will automatically switch off. In order to acti-
vate it again, press any button on the locomotive
once again (Fig. G).
Activating light and sound (Fig. D)
1. Press the light button (1d) to activate the light.
2. Press the sound button (1e) to start the sound.
Locomotive (Fig. E)
Activating light and sound
1. Press the front button (2e) to activate the
front light and the sound, and make it move
forward.
GB/IE/NI
5
Publicité
Table des Matières
