Stadler Form Oskar Mode D'emploi page 10

All manuals and user guides at all-guides.com
• do not place the appliance near a heat source. do not subject the power
cord to direct heat (such as a heated hotplate, open flames, hot iron sole
plates or heaters for example). Protect power cords from oil.
• see to it that the appliance is properly positioned to ensure a high stabil-
ity during its operation and make sure that no one can trip over the power
cord.
• the appliance is not splash-proof.
• do not store or operate the appliance outdoors.
• store the appliance in a dry place inaccessible to children (pack the ap-
pliance).
• If the power cord is damaged, it must be replaced by the manufacturer
or a repair shop authorized by the manufacturer or by similarly qualified
persons in order to prevent damage.
Preparation for use/operation
1. Place the Oskar room humidifier on a flat surface in the desired area. Plug
the mains cable (3) into a electric socket. Use the filling opening (10) to fill
the lower part (2) with water up to the maximum mark (13), either at a water
tap or with a watering can. when you have filled the lower part at the tap,
carefully fit the upper part (1) to the lower part (2).
2. start the appliance by pressing the on/off switch (5). the blue Led should
then light up. If a red pilot lamp (9) lights up however, this indicates either
lack of water in the appliance or failure to seat the upper part correctly on
the lower part.
3. By pressing the speed level selector button (6) you can change the humidity
output (a blue lamp for normal evaporation, two blue lamps for high evapora-
tion).
4. you can use the hygrostat to set the desired air humidity. to do this, press on
the hygrostat button (7). you can choose between the following levels: 40%
relative air humidity (1 blue lamp), 45% (2 blue lamps), 50% (3 blue lamps),
55% (4 blue lamps), constant operation (5 blue lamps). If the lamps are flash-
ing, this indicates that the desired air humidity has already been reached.
Please note that the hygrostat needs about 3 second to measure the current
humidity in the room. the hygrostat switches on automatically once the rela-
tive air humidity in the room sinks below the preset value. we recommend
that you set your room humidity to 45% (comfort range).
5. If you find the lamps too bright (in a bedroom for example), you may reduce
the light intensity by pressing the night mode key (8). you can choose be-
tween three different modes:
• normal mode (default mode)
• dimmed mode (push once)
• Lights-out mode (push twice)
• By pushing the dimmer button once more, you can go back into normal mode.
6. you can use the Oskar air humidifier to distribute fragrances in the room.
Please be as economical as possible in the use of fragrances, because ex-
cessive quantities may lead to malfunctions and damage to the appliance. to