Package Contents; Hardware Installation - Grandstream GWN7630LR Guide D'installation Rapide

OVERVIEW
EN
This long range Wi-Fi access point is designed to provide extended cov-
erage support and is ideal for outdoor Wi-Fi solutions thanks to its wa-
terproof casing and heat resistant technology. The GWN7630LR comes
equipped with dual-band 4x4:4 MU-MIMO technology and a sophisticat-
ed antenna design for maximum network throughput and extended Wi-
Fi coverage range of up to 300 meters. To ensure easy installation and
management, the GWN7630LR uses a controller-less distributed network
management design in which the controller is embedded within the prod-
uct's web user interface. The GWN7630LR is also supported by GWN.
Cloud, Grandstream's free cloud Wi-Fi management platform. It is the
ideal Wi-Fi AP for voice-over-Wi-Fi deployments and offers a seamless
connection with Grandstream's Wi-Fi-capable IP phones. With support
for advanced QoS, low-latency real-time applications, mesh networks,
captive portals, 200+ concurrent clients per AP and dual Gigabit network
ports with PoE/PoE+, the GWN7630LR is an ideal Wi-Fi access point for
medium wireless network deployments with medium-to-high user density.
PRECAUTIONS
• Do not attempt to open, disassemble, or modify the device.
• Do not expose this device to temperatures outside range of -30 °C to
60 °C for operating and -30 °C to 70 °C for storage.
• Do not expose the GWN7630LR to environments outside of the fol-
lowing humidity range: 10-90% RH (non-condensing).
• Do not power cycle your GWN7630LR access point during system
boot up or firmware upgrade. You may corrupt firmware images and
cause the unit to malfunction.

PACKAGE CONTENTS

4x Antennas
GWN7630LR
Access point
(PM 3.0 x 7)
1x Quick Installation
1x Base 2x Metal
Bracket Guide
Straps
4x Screws 4x Screws
4x Screw
(PA 3.5 x 33)
Anchors
~1~
GWN7630LR PORTS
Port Description
NET/POE Ethernet RJ45 port (10/100/1000Mbps) supporting
PoE/PoE+.
NET Ethernet RJ45 port (10/100/1000Mbps) to your rout-
er or another GWN76xx.
RESET Factory reset button.
Press for 7 seconds to reset factory default settings.
POWERING AND CONNECTING THE GWN7630LR
GWN7630LR can be powered on using PoE/PoE+ switch using follow-
ing steps:
Step 1: Plug a RJ45 Ethernet cable into the network port of GWN-
7630LR.
Step 2: Plug the other end into the uplink port of the power over Ethernet
(PoE/PoE+) switch.
Network Port

HARDWARE INSTALLATION

GWN7630LR can be mounted on the wall or on a metal bar, Please
refer to the following steps for the appropriate installation.
~2~
RJ45 Ethernet Cable
to power over Ethernet
(PoE/PoE+) Switch