Ultrak KAB Serie Instructions D'installation page 13

G. Pack Unit (KAK1201) Connection Jack - a RJ45 jack for the connection between the KAB series unit
and the expansion module (KAK 1201).
H. Direct Pre Out Jack - for connecting the direct pre out signal to an external amplifier, mixer or signal
processor.
I. Variable Amp In Jack - for direct signal input from external equipment (+4dB). Controlled by the
MASTER volume control on the front panel.
J. Telephone In Terminal - to be connected to telephone exchange system for paging.
NOTE: When a paging signal is connected into this terminal, all other input signals,
except AMP IN, are muted.
K. Remote Chime Terminal - When these terminals are shorted, the four-tone chime is activated. This
terminal is used for remote control activation of the chime.
L. Music On Hold Terminal (tuner installed only) - These terminals are for connecting to the telephone
system.
NOTE: When the tuner is turned on, the tuner output signal is always supplied to this
terminals and is not adjustable with the master and tuner volumes .
M. Speaker Terminal - Connect speakers between the proper impedance terminals.
VOLTAGE
MODEL
KAB 2060M
KAB 2120M
KAB 2240M
70V 100V
82 Ω
167Ω
41 Ω 83 Ω
20 Ω 42 Ω
English
NOTE: Total impedance must
be equal to or higher than the
amplifier output rated
impedance.
11