Directions For Use - Omega ColdPress 365 MM400 Mode D'emploi

DIRECTIONS FOR USE

Before the first use of product, please completely clean the components contacting ingredients.
(See Maintenance)
This product will not start working until all the parts and components are correctly assembled.
1
2
3
4
5
6
7
6
CONNECT THE JUICING BODY TO THE MACHINE BODY:
1. PUT THE CENTRAL POSITION OF THE DRUM INTO THE
OPENING IN THE CENTER OF THE FRONT OF THE BODY.
TO ALIGN THE POSITION OF "UNLOCKING SIGN" ON THE
MACHINE BODY (THE THREE FASTENERS OF THE JUICING
BODY WILL BE ALIGNED).
2. THEN ROTATE COUNTERCLOCKWISE, AND WHEN YOU
HEAR A "TICK" SOUND, IT SHOWS THAT THE JUICING BODY
IS FULLY CONNECTED.
ALIGN THE TEETH END OF THE AUGER WITH THE HOLE ON
THE BODY OF THE MACHINE. PUSH STRAIGHT INTO THE
DRUM AND INTO THE MACHINE.
IN CASE OF MISALIGNMENT, ROTATE THE AUGER
SLIGHTLY.
1. ALIGN THE WIDER END OF THE JUICE STRAINER WITH
DRUM OPENING.
2. ALIGN THE MESH TO MATCH THE DRUM BOTTOM OPENING.
ALIGN THE THREE BUCKLES ON THE ENDCAP AND THE
THREE BUCKLES ON THE DRUM. LOCK THE ENDCAP BY
TURNING COUNTER-CLOCKWISE.
BE SURE TO ALWAYS PLACE THE JUICE CONTAINER
UNDER THE JUICE SPOUT WHEN JUICING. THE JUICE
SPOUT SHOULD BE LEFT IN THE OPEN POSITION WHEN
JUICING SO JUICE CAN FLOW INTO THE JUICE CONTAINER.
IT CAN BE CLOSED TO PREVENT DRIPS WHEN THE JUICE
CONTAINER IS REMOVED.
PLACE THE PULP CONTAINER UNDER THE ENDCAP.
1. MAKE SURE THE MACHINE'S SWITCH IS ON "OFF".
2. PLUG THE POWER CORD INTO POWER OUTLET.