Setting Up; Equipment Used - Hach TPM870 Manuel D'utilisation

All manuals and user guides at all-guides.com

1. Setting up

The TPM870 instrument has been developed to meet the requirements of
electrochemical applications dedicated to water analysis. It is therefore
aimed at experienced users who have the knowledge required to operate
the instrument and implement the security instructions enclosed. We
accept no responsibility for using this measurement system (including
peripheral devices) under conditions that are not specified in this User's
Manual. This system must not, under any circumstances, be used to
perform tests on living beings.

1.1 Equipment used

. A TPM870 Turbidity Pump Module to add turbidity measure
automation to TitraLab or MeterLab system configurations (see table
below), R21T112 (in 230 V) or R21T113 (in 115V).
. A turbidimeter with an analogue measurement output (example:
2100AN IS turbidimeter from Hach).
. A manual Flow Cell Kit for 2100AN IS turbidimeter from Hach.
. < 0.1, 20, 200, 1000, 4000 and 7500 NTU standards.
. A Titration Workstation of the TIM8xx/TIM9xx range or an Ion
Analyser IONxxx. The TIM8xx, TIM9xx or IONxxx used depends on
the applications to be done.
pH measurements
Conductivity measurements
ISE Direct measurements
Potentiometric titrations
. A SAC950 sample changer fitted with a 36-position turntable for
180 ml PP sample beakers.
. A PC fitted with TitraMaster 85 Titration Software.
TitraMaster 85, version 5.1.0 or higher.
TPM870
ION450 ION570
- -
TIM865 TIM870
TIM9xx
-
-
5