Operating; Environmental Protection - BGS technic 9910 Mode D'emploi

OPERATING

1. Before starting to change the motor-oil, drive the motor until the oil has a temperature of approx. 40°-
50° C. Less temperature will reduce the flow-rate due to the high viscosity of the oil. If the oil is too hot,
the sealings of the pump might be disturbed.
2. Shut down the engine after having reached sufficient temperature.
3. Push the hose with the suction-probe onto the pump socket and push the drain hose onto the drain
socket and fasten both by using hose-clamps in order to avoid the hoses coming loose due to the oil
pressure.
4. Unwind the suction-probe and straighten it properly before inserting through the dipstick-tube into the
engine. Otherwise the pump will draw no or not enough oil.
5. Insert the suction-probe into the oil dipstick-tube and push it gently down to the lowest Position of the
oil pan.
6. Please use suitable Container to collect the old oil and lead the drain-hose into this Container.
7. Connect the oil-extractor to the 12V car-battery. Make sure that the clamps are connected with the
1. correct poles of the battery (red clamp to "plus", black clamp to "minus")
8. Switch the pump on and pump the oil out of the engine.
9. As soon as no further oil is pumped, switch off the pump. Do not let the pump run without oil.
10. Fill the engine with fresh motor-oil according to the maintenance Instruction for your car and check the
oil-Ievel with the oil dip-stick.
11. After finishing your work clean the pump thoroughly by pumping some fresh oil.
12. Remove the hoses from the pump, plug them together and Store the whole unit in a place, where it is
protected against dust.
ATTENTION:
Never let old or fresh oil seep into the ground or into the sewage system. You will harm the environment
and you will make yourself liable for prosecution. Collect the old oil and dispose at your local collecting
station, petrol station or oil-dealer.
COMPONENTS
1. Suction probe 6 mm
2. Suction connector
3. Drain connector
4. Extraction-pump
5. Battery-clamps
6. On-/Off-switch
7. Hose 10 mm

ENVIRONMENTAL PROTECTION

Recycle unwanted materials instead of disposing of them as waste. All tools, accessories
and packaging should be sorted, taken to a recycling centre and disposed of in a manner
which is compatible with the environment.
DISPOSAL
Dispose of this product at the end of its working life in compliance with the EU Directive on
Waste Electrical and Electronic Equipment. Contact your local solid waste authority for
recycling information or give the product for disposal to BGS technic KG or to an electrical
appliances retailer.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed