Télécharger Imprimer la page

Kolpin 2301 Instructions D'installation page 2

Pare-brise rabattable pour honda big red

Publicité

Les langues disponibles

Les langues disponibles

d) Install windshield to all clamps by using supplied hardware without applying final torque. Adjust position of the windshield and
tighten all screws with specified torque indicated below. Ensure that the windshield is perfectly
level before tightening. If the windshield isn't level, windshield functions will be affected.
Over tightening clamps to roll cage could cause parts failure.
e) To operate the windshield, simply remove both knobs, rotate both support arms forward and fold down the upper
windshield. Align both support arms with upper windshield holes and insert both knobs to lock position. Same
procedure to go back to previous position.
3. Maintenance and Care
Tighten all hardware after first use and periodically thereafter.
 Rinse with lukewarm water; wash gently with mild soap or detergent and lukewarm water, using a soft cloth or sponge.
 Rinse again. Dry with soft cloth or moist cellulose sponge to prevent water spotting.
 To remove wet paint, glazing compound or grease, rub lightly with a good grade of VM&P naphtha or isopropyl alcohol,
NOTICE: Abusive cleaning procedures by hand washing or automated washing equipment will eventually result in visual
- Fantastik1
- Joy2
Failure to follow these installation instructions completely may void any warrantable components and result in product
damage or personal injury.
2301 - Installation instructions for HONDA BIG RED folding windshield 2009 revision 00
Button head screw
M6 x 18
Internal lock
Washer M6
CLEANING:
DO NOT SCRUB or use brushes or squeegees.
then wash and rinse. DO NOT USE GASOLINE.
hazing, loss of light transmission and coating delamination.
Compatible Cleaning Agents
Aqueous Solution of Soaps and Detergents
- Neleco-
- Hexcel, F.O.
- Windex5
Placer
554
Knob M6 x 16
- Formula
- Lysol3
4091
IMPORTANT :
Torque specification
Max. 5 foot-pounds
Applicable to all
Clamp screws M6 x 20
(If torque tools are not available,
stop tightening as soon as both
male and female clamp parts touch
as per picture below.)
Shoulder
washer M6
- Pine-Sol4
- Mr. Clean2
- Top Job2
WWW.KOLPIN.COM
2

Publicité

loading