Midea MLH52N4AWW Manuel page 32

Problem
No power/
washer not
working or
dead
Snags, holes,
tears, rips
or excessive
wear
Control time
wrong or
changes
Not enough
water
Washer
pauses or
has to be
restarted, or
washer door
is locked and
will not open
32
Possible Cause
Washer is unplugged
Water supply is turned off • Turn cold faucet fully on.
Circuit breaker/fuse is
tripped/blown
Automatic self system
checks
Overloaded
Pens, pencils, nails,
screws or other objects
left in pockets
Pins, snaps, hooks, sharp
buttons, belt buckles,
zippers and sharp objects
left in pockets
This is normal
This is normal
Pump clogged
What To Do
• Make sure cord is
plugged securely into a
working outlet.
• Check house circuit
breaker/fuses. Replace
fuses or reset breaker.
Washer should have
separate outlet.
• First time the washer is
plugged in, automatic
checks occur. It may take
up to 2 minutes before
you can use your washer.
This is normal operation.
• The dry weight of the
load should be less than
18 lbs.
• Remove loose items from
pockets.
• Fasten snaps, hooks,
buttons and zippers.
• During spin the washer
may need to rebalance
the load sometimes
to reduce vibrations.
When this happens,
the estimated time is
increased causing time
left to increase or jump.
• Horizontal washers do
not require the tub to fill
with water like top-load
washers.
• See page 26 on how to
clean the Pump Filter.