Sonia Qaus HZ-3838 Mode D'emploi page 3

OPERATION
● Connect the bed to an electrical outlet using the power
cord.
Hand controller
1
2
- Press the button
to activate the control knob. The
red indicator will light up and all its functions can be
used.
- Press the button again and the red indicator will turn
off at the same time as the bed remains flat and in the
lowest position possible.
- Press the buttons P1, P2, P3 to place the bed in one of
the 3 factory-stored positions.
- Set any of the 3 factory-stored positions to a new
position:
• Once the bed is in the desired position, press the SET
button until the blue indicator lights up.
• While the blue indicator is lit, press one of the three
buttons (P1, P2, P3) for where you want to memorise
the new position.
• The new position will be memorised in the selected
button.
● Adjusting height and tilt
- Use the buttons and
adjust the height of the bed, and the motors inside each
column will move at the same time.
of the hand controller to
- Use the buttons
1 and
adjust the height and/or tilt of the bed, and the motors
inside each column will move independently.
● Adjusting backrest tilt
- Use the buttons
and
adjust the tilt of the backrest.
● Adjusting footrest tilt
- Use the buttons
and
adjust the tilt of the footrest.
Manual functions
● Adjusting the armrest
- To lower the armrests, move the lever operating the gas
piston and press down on the armrest to the desired
position. When you release the lever, the armrest will
stay in its current position.
2 of the hand controller to
of the hand controller to
of the hand controller to
EN
3