Power Supply Failure - Inventum VDW9001B Mode D'emploi

POWER SUPPLY FAILURE

When power supply is resumed, the signal light on the
Start/Pause button will flash.
To resume the drying process, press Start/Pause.
END OF THE DRYING PROGRAMME
At the end of the drying programme, »End« will appear on the display unit, and the two red
indicator lights will light up. The Start/Pause button light and Anti Crease time indicator,
if activated or selected, will flash.
1. Open the dryer door.
2. Clean the filter (see the section »MAINTENANCE AND CLEANING«).
3. Take the laundry from the drum.
4. Close the door!
5. Switch off the dryer (press the On/Off button).
6. Empty the condensate tank.
7. Unplug the power cord from the outlet.
After the end of the drying programme, immediately remove the laundry from the dryer to
prevent it from creasing again.
SAVING PERSONAL SETTINGS
Initial settings may be changed.
When the programme and additional functions are selected, you may store such a combination
by pressing the Start/Pause button and holding it for five seconds. An indicator light on the Start/
Pause button and an acoustic signal will confirm your selection. »S C« (settings changed) will be
displayed briefly on the display.
Press the Start/Pause button to start the drying process.
The changed combination will appear every time you switch on the dryer.
Follow the same procedure to change a previously saved combination.
PERSONAL SETTINGS MENU
Switch on the dryer by pressing the On/Off button. To open the personal settings menu,
simultaneously press the positions START DELAY [startuitstel] and ANTI CREASE
[anti-kreuk] and hold them for 3 seconds. The symbols for START DELAY, DRYING TIME,
FILTER, and CONDENSATE TANK will be lit on the display unit. Number 1 will appear on the LED
display, indicating the settings function. Rotate the programme selector knob to the left or to
the right to choose the function to change. Number 1 indicates sound settings and number 2
indicates resetting of Personal programme settings to factory defaults. If the desired settings
are not selected in 20 seconds, the programme will automatically return to the main menu.
49
English •