Ferm CDM1113S Traduction De La Notice Originale page 9

sleeve (8) with your other hand in clockwise
direction until it is opened far enough for the
bit to slide in.
• I nsert the shaft of the drill or screwdriver bit
• T ighten the drill chuck again by firmly rotating
the chuck sleeve (8) counterclockwise.
• C heck if the bit is centered well by shortly
activating the machine´s on/off switch.
Adjusting the gears
Fig. F
Never switch gears when the motor is
running, this will damage your machine.
Never put switch in the middle between
both positions, this will damage your
machine
The machine has 2 drill speeds, which can be
adjusted by sliding the gear switch (9) forward or
backwards. The number on the gear switch (9)
shows which position is chosen.
• P osition 1: For slow drilling, large drilling
diameter or screw driving. The machine has
high power at a low speed.
• P osition 2: For fast drilling or small drilling
diameter
Adjusting the direction of rotation
Fig. G
• S et the direction switch (10) to position "" in
order to drive screws or to use it for drilling.
• S et the direction switch (10) to position "" in
order to remove screws
Switching the machine on and off
Fig. G
The on/off switch (11) is used for activating the
machine and adjusting rotation speed.
• P ressing the on/off switch (11) will activate
the machine, the further the switch is being
pushed, the faster the drill will turn.
• R eleasing the on/off switch (11) will stop the
machine.
• M ove the direction reversing switch (10) to the
middle position to lock the movement of the
on/off switch. It cannot be activated in this
position.
All manuals and user guides at all-guides.com
Adjusting the torque
Fig. G
The machine has 23 different torque settings
and a special drill mode to set the power being
transmitted to the chuck.
By rotating the torque adjustment ring (12),
screws can be driven to a predetermined depth,
which is ideal for repetitive work. The higher the
number, the more torque will be transmitted.
• S elect a low setting for small screws or soft
work material.
• S elect a high setting for large screws, hard
work materials and when removing screws.
• Y ou should preferably choose a setting as
low as possible when driving screws. Select
a higher setting if the motor slips before the
screw is fully tightened.
• F or drilling, turn the torque adjustment ring
(12) to the setting for drilling by fully turning it
counterclockwise.
Work light (13)
Fig. A
The machine is equipped with a work light to
illuminate the work location.
• I t automatically switches on when the on/off
switch is being pressed.
• I t automatically switches off when the on/off
switch is released again.
Only lay down the machine when it has
stopped running completely. Do not
place it on a dusty surface as particles of
dust could get into the mechanism.
Ensure that the direction switch (10) is
always set to  during drilling.
The machine is equipped with electronic
overload protection function. When the
machine gets overloaded it will shut
down automatically. When this happens,
please wait for at least 5 seconds to let
the overload protection reset itself.
9