GOWEIL MS 100 Manuel D'utilisation page 57

6.6 Adjusting the grinding angle Adjusting the grinding angle
Pos : 7.18 /KN 2006-SM /Bedi enung/007 1.1 Stillsetzen i m N otfall --> Anl age und grösser e M asc hine @ 9\mod_1144432835796_1.doc @ 86788
6.7 Adjusting the rotation limiter Adjusting the rotation limiter
Pos : 7.18 /KN 2006-SM /Bedi enung/007 1.1 Stillsetzen i m N otfall --> Anl age und grösser e M asc hine @ 9\mod_1144432835796_1.doc @ 86788
6.8 Operation
Personal protective
equipment
10.03.2009
All manuals and user guides at all-guides.com
As it is different for the different types of knive s, the grinding angle must be adjustable. As it is different for the different types of
The following steps are necessary: The following steps are necessary:
. device and rests safely against the end stop bolts. Also make sure that the curved knife is securely clamped into the horizontal clamping
device and rests safely against the end stop bolts.
1. Loosen the clamping lever on one side. Loosen the clamping lever on one side.
2. Hold the electric motor with one hand while loosening the second clamping lever. Hold the electric motor with one hand while loosening the second clamping lever. Hold the electric motor with one hand while loosening the second clamping lever.
ATTENTION!
When opening the second clamping lever, hold the electric motor only at
the front, as there is a RISK OF INJURY at the rear!! the front, as there is a RISK OF INJURY at the rear!!
3. Adjust the grinding angle before retightening both clamping levers. Adjust the grinding angle before retightening both clamping levers. Adjust the grinding angle before retightening both clamping levers.
TIP!
Setting the right grinding angle is easier for new knive s.
The rotation limiter (end stop) must be set in such a way that the cup grinding wheel remains inside The rotation limiter (end stop) must be set in such a way that the cup grinding wheel remains inside The rotation limiter (end stop) must be set in such a way that the cup grinding wheel remains inside
the cutting surface and does not grind over the edge at the beginning or the end of the knife. the cutting surface and does not grind over the edge at the beginning or the end of the the cutting surface and does not grind over the edge at the beginning or the end of the
The adjustment can be made for each knife. The adjustment can be made for each
1. Undo the star screw. Undo the
2. Make the adjustment. Make the adjustment.
3. Retighten the star screw. Retighten the star screw.
Always wear the following protective equipment when operating the machine: Always wear the following protective equipment when operating the machine: Always wear the following protective equipment when operating the machine:
Protective clothing Protective clothing
Safety shoes Safety shoes
Safety goggles Safety goggles
Hearing protection Hearing protection
s, the grinding angle must be adjustable.
is securely clamped into the horizontal clamping
the second clamping lever, hold the electric motor only at
Knife sharpener MS 100 Knife sharpener
Operation
s.
21