Dolby Headphone - Denon AVR-5800 Mode D'emploi

6 q Select the various surround parameters.
(Remote control unit)
• DEFAULT setting
Select "Default Yes 0" then parameters set to default setting.
(Remote control unit)
7
Press the SURR.PARA. button to complete the setting.
(Remote control unit)
NOTE:
• When making parameter settings, the display
will return to the regular condition several
seconds after the last button (main unit) was
pressed and the setting will be completed.
w Adjust the parameter setting.
(Remote control unit)
Surround parameters e
Pro Logic II Mode:
The Cinema mode is for use with stereo television
shows and all programs encoded Dolby Surround.
The Music mode is recommended as the standard
mode for autosound music systems (no video),
and is optional for A/V systems.
The Pro Logic Emulation mode offers the same
robust surround processing as original Pro Logic in
case the source contents is not of optimum quality.
Select one of the modes ("Cinema", "Music" or
"EML").
Panorama Control:
This mode extends the front stereo image to
include the surround speakers for an exciting
"wraparound" effect with side wall imaging.
Select "OFF" or "ON".
Dimension Control:
This control gradually adjust the soundfield either
towards the front or towards the rear.
The control can be set in 7 steps from 0 to 6.
Center Width Control:
This control adjust the center image so it may be
heard only from the center speaker; only from the
left/right speakers as a phantom image; or from all
three front speakers to varying degrees.
The control can be set in 8 steps from 0 to 7.

Dolby Headphone

The Dolby Headphone mode is set when headphones are connected to the
PHONES jack while in the DOLBY/DTS SURROUND mode.
1
When the SURR. PARA.
button is pressed, the
parameter selection screen
appears.
(Remote control unit)
2 q Select the parameter. w Select the setting.
(Remote control unit)
3
Press the SURR.PARA. button to complete the setting.
(Remote control unit)
Parameters
MODE:
DH1.............Reference room (small room with weak reverberations)
DH2.............Live room (room with a bit stronger reverberations than DH1)
DH3.............Large room (larger room than DH1, offers a sense of distance and sound diffusion effects)
BYPASS.......Stereo sound.
DECODER:
Select this when playing analog, PCM or other 2-channel sources.
The signals are converted into multichannel signals using the decoders shown below and played in the Dolby
Headphone mode.
This is not displayed in the BYPASS mode.
PL II C .........Dolby Pro Logic II Cinema mode
PL II M ........Dolby Pro Logic II MusicMode
NEO:6 C......DTS NEO:6 Cinema mode
NEO:6 M.....DTS NEO:6 Music mode
OFF .............The signals are played in the Dolby Headphone mode as such (2 channels).
– Recording –
When RECOUT mode is set to "SOURCE", with this amplifier signals encoded in the Dolby Headphone mode
can be output from the recording output terminals and recorded on another recorder.
1. The Dolby Headphone play mode is set when headphones are connected to the PHONES jack during
playback in the DOLBY/DTS surround mode.
2. When this is done, signals encoded in the Dolby Headphone mode are automatically output from the
recording output terminals (analog and digital) and can be recorded.
3. Select the parameters and set the desired mode, then record.
NOTE:
Do not disconnect the headphones during recording.
ENGLISH
2
(Remote control unit)
1, 3
7