NOSTALGIA PRODUCTS PT300RETRORED Consignes Et Recettes page 10

All manuals and user guides at all-guides.com
ATTACHING BLADES TO BLADE MOUNT
USE EXTREME CAUTION when handling all Blades! They are
extremely sharp and may cause injury if used improperly.
1. Take note of the notches on the Blade
Mount. Make sure the Peeling Arm
Release is in the down position.
3. Simultaneously push top of Blade back
while pushing bottom of Blade towards
Fork Mount to snap into place. Some
may find it easiest to secure using two
hands on either side of the Blade.
REMOVING BLADES FROM BLADE MOUNT
1. Simultaneously push bottom of Blade back
while pushing top of Blade towards Fork
Mount to remove. Blade will click upon
removal.
2. Angle and slide chosen Blade between
the two notches on the arm of the Blade
Mount as shown below.
4. When secured, Blade will click and stand
vertical.
NOTE: Once attached, Blade is difficult
to remove. Removing Blade requires
more pressure than attaching. Some
may find it easiest to remove using two
hands on either side of the Blade.
8